GPIB to Modbus RTU Interface Board

ICS's Model 4809A GPIB to Modbus RTU Interface uses a simple, GPIB friendly command set to control Modbus RTU slave devices. The Model 4809A is easily controllable with any GPIB Controller and test application software such as Agilent VEE, National Instruments' LabVIEW, Visual Basic and C/C++.

Model 4809A GPIB to Modbus RTU Interface		4809A Data Sheet
	• Adds an IEEE-488.2 Interface to any Modbus RTU device. • Converts simple ASCII commands into Modbus RTU messages • Includes floating point commands for newer Modbus Controllers. • Handles all packet formatting,CRC generation and response checking. • Provides single ended RS-232 and differential RS-485 output signals. • Easily configured from GPIB bus with SCPI commands. All settings are saved in non-volatile flash • Diagnostic LEDs show address and operating status. • Small board easily mounts inside a test chamber or other chassis. • Connects to a GPIB Connector on the rear panel of the chassis with a GPIB Connector/Address Switch Cable or with a GPIB Flat-Ribbon Cable.	See also GPIB Connector/ Address Switch Cables GPIB Accessories


Model 4809A GPIB to Modbus RTU converter RS-232 and RS-485 Slave Devices